Pile testing is performed according to standards:
LVS EN 1997-1; ISO/DIS 22477-1; ГOСТ 5686-2012
The piles can be tested by the following methods:
Testing of bored piles using reinforced concrete blocks - this test method can be used if the load is intended up to 2100kN.
Piles can be tested by building additional anchor piles or temporary screw piles, this method is used if the load on the pile is more than 2100kN
Ultrasonic pile integrity test (PIT) allows the detection of defects (cracks, extensions, constrictions, hollows due to soil exposure, voids) as well as pile lengths. No European standard is available for this test, the pile integrity test report is developed in accordance with EN1536
PILE STATIC TESTING
Static testing - bearing capacity check of the pile. The static pile testing may be conducted:
Using reinforced concrete blocks
Using additionally arranged anchor piles
PILE INTEGRITY TESTING (WITH ULTRASOUND)
The Pile Integrity Test - PIT - this method enables to detect the defects of single piles (ruptures, broadenings, narrowing, hollows resulting from the effect of soil, holes) and to determine the pile length.
Ultrasonic pile inspection
PILE DYNAMIC TESTING
Adapter for piles
The dynamic test (DLT) allows to determine the piles foundation and side surfaces bearing capacity, to evaluate the piles integrity as well as their subsidence. The measurements are analyzed in real time using special software. One of the test results is a simulation of the static test in a form a calculated load-test curve.
The test is performed with manufactured free-fall hammer, which we have owned since 2021
Registration number: 50103005351
Adress: Spilves street 18, Riga, LV 1055, Latvia
Bank: OP Corporate Bank plc Latvia
SWIFT code: OKOYLV2X
Bank account number.: LV82OKOY0005100035077